|
Snowboard Wrap Installation
Guide
Materials & Tools Needed before
installing your snowboard wrap:
- Denatured or rubbing Alcohol mixed
with water. You will need equal parts of water and alcohol. 50/50
- Blow Dryer
- A squeegee (That we provide to you.)
- Window Cleaner
- Single Edge Razor Blade (An exacto
blade is easier to use if you have access to that.)
- 2" masking tape (for hinge)
- Camera to send us a picture to post
on our website
- Your ipod for musical inspiration
while installing
Prepping Your Board:
Pull off any stickers with the heat of a blow dryer if needed. Then
remove glue with the 50/50 Alcohol and water mixture. The goal is to
have your board squeeky clean with no oils.
Clean the board with Windex then your 50/50 Alcohol and water mixture
again. Remember (Squeeky Clean)
Now your board should be ready for installation!
Take a 2nd look and make sure your board is
squeeky clean.
1. Hold your graphic over the top of the
board to place your graphic for position.
2. Tape across center (hinge).
3. Lift up left side hold vinyl in hand, then
pull off the paper to the tape hinge. Cut the paper so you have the vinyl in
your hand. Squeegee from the center out to the end of the board. 1 side
done! Repeat steps 1-3 for send side of board.
4. Repeat steps 1-3 for second side of
board.
5. Run a razor blade at an angle around the
board to trim off excess.
6. Just ride the edge of the board as a
guide. *** Hint: When you are running around your board with a blade, be
careful of your edges as they are very sharp.
How does it look? It should be great! The
glue sets up better after 24 hours. (Leave at room temperature.)
|
